Ohiosam
*Supporting Member*
Last summer I bought a Bridgeport mill at an auction. Just an older basic model, no digital read out or power feed on the table. I brought it home drenched it with oil and put it in the barn. Finally got it in the shop today. It probably weighs 1800-2000 pounds, it's 50" wide x 62" deep x 78" tall. Problem is the shop door is 37"x72". So I tilted the head 90degrees to get it short enough, ran the table all the way to the left. Picked it up with the skid steer by a very short piece of chain so I could swivel it through the door. Set it on some pipes and rolled it in to place. Nothing to it except for some reason I felt the need for 3 ibuprofen when I finished. Had a guy helping, defiantly not a one man job. Still have to wire it, it's 3ph and I have a converter.